Rhino3D v5 WIP

Finally, a public development has started, and McNeel released first WIP release. Check out whats new and try it out.
64-bit Windows Supported:
The 64-bit version of Rhino 5.0 can use as much system memory as is available from the operating system. This allows you to open and edit models that are much larger than you could edit in Rhino 4.0.
The 32- and 64-bit versions of Rhino can be installed and run on the same computer at the same time.
Backward Compatible:
Rhino 4.0 Plug-ins will load and run in the 32-bit version of Rhino 5.0. Plug-ins will need to be recompiled for the 64-bit version of Rhino by the plug-in developer. Until they’re ready, you may need to run the 32- and 64-bit versions of Rhino 5.0 side by side.
New Features:
Many Rhino Labs plug-ins have been included in this Rhino 5.0 WIP. Plus several other new features have been added. A list is available on the What’s New in Rhino 5.0 WIP page.
System Requirements:

* 32-bit or 64-bit version of Windows 2000, XP, or Vista
* Rhino 4.0
* 100MB of disk space
* 2GB RAM (4-16GB recommended for 64-bit systems and very large models)

Download Now:
For a list of new features and to download, please visit http://download.rhino3d.com/rhino/5.0/wip
Join the discussion:
Visit news://news.mcneel.com/rhino to talk directly with our developers, read about what we’re doing, share your ideas, and report any problems you experience.

Leave a Reply

You must be logged in to post a comment.