November 28th

Jewelry, Modeling, Tutorials, Video

4 Comments

This article has been viewed 5736 times. You can leave a response, or trackback from your own site.

Modeling Piped Ring Jewelry in Rhino

Again, Cosef shares his great knowledge on jewelry modeling in Rhino. This time he shows us how to model simple but nice piped ring.

Related posts

• Modeling cinch connector (7)
• Modeling Rowenta Hair Dryer (12)
• Modeling Kent hair brush (14)
• Modeling a wind-up clock (0)
• Rendering Desk Lamp in Vray (17)

used 10 commands

Arc, Circle, ExtrudeCrv, Line, Mirror, Pipe, PointsOff, PointsOn, Rebuild, Rotate

4 Responses to “Modeling Piped Ring Jewelry in Rhino”

1. Hannes says:

   December 3, 2009 at 12:03 am

   How to get this round edit points in rhino??? Wanna have it too!
2. roy says:

   December 3, 2009 at 9:16 am

   great tutorial!
   like this site too! very useful for rhino users!

   btw, what screen recording program are you using?
3. Cosef says:

   January 4, 2010 at 1:10 pm

   Hi everyone. I’m Cosef the maker of this tutorial

   @Roy i use camtasia6 for recording.
   @Hannes Edit points are square shapped.
4. METANSK says:

   January 21, 2010 at 12:31 pm

   great tutorial, thank you!..