May 16th

Forum Help, Video

2 Comments



This article has been viewed 33988 times. You can leave a response, or trackback from your own site.



Curve control help in forums video

disconnected_lines.jpg
Just a little step-by-step video help on using snap and creating accurate curves.

Go to the disconnected lines thread

[flashvideo filename=http://www.rhino3dhelp.com/wp-content/uploads/2008/05/forum_help/disconnected_lines.flv /]

2 Responses to “Curve control help in forums video”

  1. gord bradford says:
    August 18, 2008 at 5:21 pm

    This is a great video, which I will study later.

    I am working on an outrigger hull (one of my first projects) and having difficulties which may be solved by this video.

    I wish it had audio.

  2. 海蓝天 says:
    September 23, 2008 at 2:42 pm

    where and how to download zhe film?

Leave a Reply